Emos E8010 Manual De Instrucciones página 6

7 – MAX/MIN
8 – CH
9 – RESET
10 – battery compartment
Sensor Description (See Fig. 3)
A – LED of signal transmission from the
sensor
B – hole for hanging
Putting the Device into Operation
1. Connect the power adapter to the weather station and insert the batteries (2× 1.5 V AA). Then
insert batteries into the wireless sensor (2× 1.5 V AAA). When inserting the batteries, make sure
the polarity is correct to avoid damaging the weather station or sensor. Only use 1.5 V alkaline
batteries of the same type; do not use rechargeable 1.2 V batteries. The lower voltage may cause
both of the units to not function.
2. Place the two units next to each other. The weather station will detect the sensor signal within
3 minutes. If signal from the sensor is not detected, long press the CH button on the weather
station to repeat the search.
3. We recommend placing the sensor on the north side of the house. The range of the sensor may
decrease substantially in areas with a large number of obstacles.
4. The sensor is resistant to dripping water, however, it should not be permanently exposed to rain.
5. Do not place the sensor onto metal objects; doing so will reduce the transmission range.
6. If the low battery icon is displayed on the screen, replace batteries in the sensor or weather
station.
Switching Channels and Connecting Additional Sensors
1. Choose the sensor channel number (1, 2, or 3) by repeatedly pressing the CH button on the
station. Then long press the CH button; the
2. Remove the battery cover on the back of the sensor and move the channel selector switch to
the sensor channel number of choice (1, 2, 3).
3. Insert batteries into the sensor (2× 1.5 V AAA).
4. Data from the sensor will be loaded within 3 minutes.
5. Repeat the process if the sensor's signal is not detected.
Weather Station RESET
If the weather station displays incorrect information or does not respond to button presses, remove
batteries from the sensor and the station and disconnect the power adapter.
Wait 10 minutes.
Then put the batteries back in and reconnect the adapter.
This will erase all data; you will need to set the weather station again.
Displaying Data from Multiple Sensors, Automatic Cycling through Values from
Connected Sensors
Press the CH button repeatedly to display data from all connected sensors one by one. You can also
activate automatic cycling through the data from all connected sensors:
1. Turning on cycling
Repeatedly press the CH button until the
Data from all connected sensors will be shown automatically and repeatedly one after another.
2. Turning off cycling
Repeatedly press the CH button until the
Radio-Controlled Clock (DCF77)
After being registered by the wireless sensor, the weather station will automatically start searching
for DCF77 signal (DCF for short) for 7 minutes; the
will turn off and only temporary screen illumination will be working. No other items on the screen
will be updated and the buttons will be disabled (except SNOOZE/LIGHT). Wireless charging will not
11 – power adapter socket
12 – battery cover
13 – SNOOZE/LIGHT
14 – charging surface
C – channel selector switch (1, 2, 3)
D – battery compartment
E – battery cover
icon will start flashing.
icon appears on the screen.
icon disappears.
icon flashes. During the search, the screen
6