Emos E8010 Manual De Instrucciones página 8

Displaying Max/Min Measured Temperature and Humidity
Maximum and minimum readings of the measured indoor and outdoor temperature and humidity are
automatically recorded in the memory of the weather station. Press repeatedly MAX/MIN to display
the readings measured.
The memory of measured values is automatically erased every day at 00:00.
You can also clear the memory by long-pressing the MAX/MIN button.
Setting Outdoor Temperature Limits
Temperature limits can be set independently for up to 3 outdoor temperature sensors.
Min
Max
Resolution
Press the CH button repeatedly to select sensor no. 1, 2 or 3 and proceed as follows for each sensor.
1. Long-press the ALERT button.
2. The max temperature icon
confirm by pressing the ALERT button.
3. The min temperature icon
confirm by pressing the ALERT button.
4. Then short-press the ALERT button to activate the function;
5. When the set temperature limit is exceeded, an acoustic alert will activate for 1 minute and the
temperature value will begin flashing.
Pressing any button on the screen cancels the alert sound, but the icon of an active alert and
the temperature value will continue flashing. Once temperature drops below the set limit, the
icon and the temperature value on the screen will stop flashing.
6. Pressing the ALERT button again deactivates the function; the
Setting an Alarm
The weather station allows setting 2 alarms.
A1 = setting only for workdays: Monday to Friday.
A2 = setting only for weekends: Saturday, Sunday.
Choose the alarm you want to set:
1. Press the ALARM button 1× to open settings for alarm A1.
Press the ALARM button 2× to open settings for alarm A2.
2. Long-press the ALARM button – the time setting will start flashing.
3. Use the and
speeds up adjustment.
Confirm the set value by pressing the ALARM button.
Activate the alarm by short-pressing the
.
Pressing the button again deactivates the alarm; the
Snooze Function
The ringing of the alarm can be postponed by 5 minutes using the SNOOZE/LIGHT button located on
the top of the weather station.
Press the button when the alarm starts ringing. The alarm icon and
To cancel SNOOZE mode, press any other button – the
remain on the screen.
The alarm will trigger again the next day.
Station Screen Illumination
When powered via adapter:
Permanent screen illumination is set by default.
-20 °C to +49 °C
-19 °C to +50 °C
1 °C
will start flashing, use the
will start flashing, use the
buttons to set the hours and minutes for the alarm; holding the button down
button again; the screen will display one or both icons
icon disappears.
icon will stop flashing and
8
buttons to set the value and
buttons to set the value and
icons will appear on the screen.
icons will not be displayed.
will be flashing.
will