Monogram ZGP484NG Instrucciones De Instalación página 20

ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessory Installation
ACCESSORIES—30" TO 36" ADJUSTABLE BACKSPLASH (not included)
A WARNING:
To prevent ignition of combustible materials,
the entire back wall above the range must be
protected by a backsplash constructed of non-
BEFORE YOU BEGIN
combustible material.
Read these instructions completely
and carefully.
IMPORTANT: Save these instructions for local
inspector's use.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these
instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with your Owner's Manual for future reference.
¢ This backsplash adjusts to fit the space between
the top of the range and the bottom of the hood,
from 30" Min. to 36" Max. height.
¢ Maximum shelf load-bearing weight is 40 Ibs.
TOOLS AND MATERIALS REQUIRED
¢ Gloves to protect against sharp edges
¢T-15 and #2 Phillips screwdrivers
* Drill with 3/32" and 9/64" bits
Safety glasses
e Level
e Pencil
This Kit Includes
¢ Top wall support
¢ Bottom wall support
¢Top cover with shelf
* Bottom cover
¢ Hardware package with
- 9 Stainless Steel Torx 15 #8
self-tapping screws
- 9 Phillips #2 pan head wood #10 screws
- 3 Stainless Steel #2 truss head
#10 screws (for alternate
installation method)
Top Wall
Support
Bottom Cover
Bottom Wall Support
Hardware
Package
20
INSTALL THE WALL SUPPORT PANELS
A WARNING: The wall support panels must
be securely fastened to the wall. Failure to do so
could result in damage or personal injury.
IMPORTANT: This backsplash is designed to cover the wall
between the bottom of the hood and the top of the range.
The vent hood should be installed over the rangetop or
range before installing this backsplash.
¢ Install and level the Range/Rangetop according to the
product installation instructions.
¢ Remove backsplash packaging and protective film.
e Locate wall studs on each side. Where studs are not
available, plan to use wall anchors (not provided].
e Use a level to pencil 2 horizontal lines on the wall, one
1/8" below the vent hood anc the other 1/8" above the
Range/Rangetop. This 1/8" space allows the cover panels
to overlap the wall supports.
¢ Secure the top wall support panel to the wall with 4 wood
screws, through the outermost studs.
e Use 4 wood screws to secure the bottom wall support
panel. The center slot should be positioned at the top.
The gap between the top and bottom support panels will be
covered by the top cover with shelf.
Secure the
top panel to
the wall with 4
wood screws
Wood secure the
Screws bottom panel
o to the wall
with 4 wood
screws