Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions for Gas Conversion
CHANGE BURNER ORIFICES (cont.)
IMPORTANT: Find your model number below. Read
each orifice label to identify and install them in the
exact locations shown.
ZGP304 SIMMER ORIFICES
LP
Nat
Cc
A 34SL or 515SN orifice
will be used on all burners.
ZGP304 MAIN ORIFICES
LP.
Na
84XL_
||126HXN
—
Ke
Use a 108XL or
190XN orifice for
the right front
burner.
A 84XL or 126HXN
orifice will be
used on these
ip
Na
ZGP364, ZGP366, ZGP484, ZGP486
SIMMER
A 34SL or 51SN orifice
ORIFICES
will be used on all
burners.
MAIN
Use 108XL or
ORIFICES
190XN orifices for
all burners.
A. Return the unused orifices to the holder. Reattach
the holder and the instruction sheet with screw
in the original storage location.
B. Replace the burner heads, caps and top grates.
On range models, replace rear vent trim.
23
CHANGE GRILL ORIFICE (if present)
Locate the 1-1/2" long Grill orifice.
Select the proper orifice size for your gas and
burner from the conversion chart.
A. Remove the grill cover, grates and grate
frame. Lift the radiant baffle straight up and off.
B. Remove the 2 hex
head screws from the
top of the igniter.
* Remove one screw
from each side of the
burner surround.
* Lift out the surround.
TAMU OOO GORRRRRREORO
OOOO
ANROOOO
[
Remove
2 hex
head
screws
C. Carefully push the igniter aside and under the burner.
Do not pull or pinch the wire.
Remove 4 burner attachment screws, 2 at the front and
2 at the back. Slide the burner assembly toward the
back and out of the gas inlet.
Burner
| Bag
Igniter
Surround
N
D. Use a 1/2" deep well
socket to remove and
replace the orifice .
Reverse these steps
to re-assemble the
grill. Be sure to place
the unused orifice in
the holder for possible
future use.
Publicidad
