Publicidad
Idiomas disponibles
Idiomas disponibles
Installing Adapter Brackets
• Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
To prevent scratching the display, set a cloth on a flat, level surface that will support the weight of the display.
7
Place display face side down. If display has knobs on the back, remove them to allow the adapter brackets to be
attached. Place adapter brackets (BB) on back of display, align to holes, and center on back of display as shown
below. Attach the adapter brackets to the back of the display using the appropriate combination of screws, multi-
washers, and spacers as shown in figure 7.1 and figure 7.2.
NOTE: Top and bottom holes on display must always be used.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
NOTE: If using security screws, tighten using security allen wrench (CC).
Notes:
• The number of fasteners used will vary,
depending upon the type of display.
• Multi-washers and spacers may not be used,
depending upon the type of display.
• Use the corresponding hole in the multi-
washer that matches your screw size as shown.
NOTE: For flat back displays proceed to step 7-1. For bump-out or recessed back display skip to step 7-2
WARNING
BB
CENTER BRACKETS
VERTICALLY ON BACK
OF DISPLAY
Note: "X" dimensions should be equal.
X
X
MEDIUM HOLE FOR M5 SCREWS
LARGE HOLE FOR M6 SCREWS
10 of 40
ISSUED: 2006-05-06 SHEET #: 202-9141-14
MULTI-WASHER
(2023-01-31)
Publicidad
