Publicidad
Idiomas disponibles
Idiomas disponibles
Depending on the specific size & weight of the
9
plasma, articulating swing arm may be angled at
different positions, causing plasma to appear to lean
sideways at different articulating positions. Tilt-roll
assembly (B) allows plasma to be manually adjusted,
so plasma can be horizontal at all positions. To adjust,
gently rotate plasma by hand to desired position.
ARTICULATING
ARM
FOR PLAV60 ONLY:
10
Position of display may be adjusted vertically up to .79" in
each direction by doing the following:
• To lower display, turn socket screw shown in figure 10.1
clockwise with 10mm allen wrench (V).
• To raise display, turn socket screw shown in figure 10.1
counterclockwise with 10mm allen wrench (V).
SOCKET
SCREW
PLASMA
fig. 10.1
If it is too difficult to adjust roll of plasma, loosen
9-1
screws shown in figure 9.1 using a phillips screw-
driver.
IMPORTANT! Do not loosen or tighten screws
more than 1/8 turn.
13 of 40
ISSUED: 2006-05-06 SHEET #: 202-9141-14
All other brand and product names are trademarks or registered trademarks of their respective owners.
ROLL
ADJUSTMENT
SCREWS
fig. 9.1
© 2023, Peerless Industries, Inc. All rights reserved.
(2023-01-31)
Publicidad
