Blackmagic Design 2110 IP Converter 3x3G Manual De Instalación Y Funcionamiento página 7

Your Blackmagic 2110 IP converters are now connected. You can also connect Blackmagic 2110
IP Converter 3x3G to a network with other IP video equipment including DeckLink IP and NMOS
controllers. Please keep reading the next section of this manual for information on how to
connect your Blackmagic 2110 IP Converter 3x3G to a 10G network switch to share multiple HD
video feeds over a network.
Setting up a Network
If this is your first time setting up a 10G network for streaming ST 2110 IP video, there are few
considerations you should take into account when getting started. IP media is sent in packets,
so it's important to have a PTP aware switch to provide the timing information to synchronize
the devices connected to the network. The management of the traffic flow is covered by a
separate control system named NMOS that can be added to the network via either a software
or hardware solution.
PTP Grandmaster
10G managed switch
SDI
OUT
SDI
IN
ETHE
RNET
+12V
+12V
SDI
OUT
SDI IN
ETHE RNET
+12V
+12V
Connecting to a Network Switch
Your network switch needs to be a managed 10G network switch that supports IGMP version
3 snooping.
Managed switches provide monitoring and control of traffic over the network and require
configuration to get started. The size of you network switch depends on how much traffic you
might need. For instance, an 8 port 10G Ethernet switch has a capacity of 160Gbps and a 16
port switch will allow up to 320Gbps.
The following 10G network switches have been tested with Blackmagic 2110 IP Converter 3x3G:
Manufacturer
Ubiquiti
The switch needs to be Internet Group Management Protocol, or IGMP L3 enabled. IGMP is a
communication protocol that allows the switch to route multicast data.
With multicasting one stream can be subscribed to by multiple outputs while only using the
bandwidth of one single stream.
STATUS
1 13 2 14 3
System
Reset
SG200-26 26-Port Gigabit Smart Switch
NMOS Controller
Model
Enterprise XG-24
INPUTS OUTPUTS FRONT PANEL
ENTER REF BLACK SDI EMBED SYSTEM ENABLE
TIME LTC CMPST AES PTP
USB
BACK INT EXT TIME PWR1 PWR2 FAULT
15 4 16 5 17 6 18 7 19 8 20 9 21 10 22 11 23 12 24
G25 G26 SFP
MENU
SEARCH
SET
INPUT DISP DELAY H/V BLUE ONLY ZOOM PEAK LUT 1 3D LUT 2 3D MARK H MARK V
Setting up a Network 7