Beninca BOB3024E Manual página 11

8) ELECTRIC CONNECTIONS
The cables necessary for the installation of BOB can vary according to the accessories installed.
No connection cable is supplied.
Fig. 7 indicates the cables for standard installation.
List of cables
Connection
A Mains power supply to the control unit
B Motor connection
C Photocell transmitter connection
D Photocell receiver connection
E Key selector connection for external command
F Flashing signal light connection
G Connection of the aerial built-in the flashing light
Legenda
1 Motoreducer
2 Photo-electric cells
3 Key selector (external) or digital keyboard
4 Flash-light
5 Electronic board
The cables used must be suitable for the type of connection. For example, for connection protected by raceways use
H03VV-F cables, for cables in the outdoor environment always use the H07RN-F type.
TECHNICAL DATA
Power supply
Absorbed current
Thrust
Jogging
Protection degree
Operating temperature
Useful stroke:
- with 2 stoppers
- without stoppers
Noise level
Lubrication
Weight
Type
3x1,5mm
2
4x1,5mm (3x0,5mm
2
2x1,0mm 2
4x1,0mm 2
2x1,0mm
2
2x1,5mm
2
RG 58
BOB2124 E
24Vdc
5,5 A
1800 N
Intensiv
IP44
-20°C / +50°C
270 mm
325 mm
<70 dB
Permanent
grease
8,2 kg
BOB 30ME)
2
BOB3024 E
8,2 kg
11