INSTALLATION INSTRUCTIONS ( CONTINUED )
Install Hose and Nozzle
NOTE: Dispensing hose and nozzle are not included with model M-1115S-PO.
1.
Using pliers, remove the plastic plug from outlet port on front of pump. Wrap
one end of the dispensing hose with three to four turns of thread tape and
thread into outlet port (see Figure 8). Tighten securely using an adjustable
wrench.
2.
Wrap opposite end of hose with three or four turns of thread tape and thread
into nozzle. Tighten securely using an adjustable wrench
(see Figure 9).
3.
Place the nozzle into the nozzle holder on the end of the pump motor
housing. Note that the nozzle cannot be placed in the holder unless
the pump switch is OFF (see Figure 10).
Figure 8
Figure 10
EN
Figure 9
9