Husqvarna 525HE3 Manual Del Usuario página 11

3. Hold the body of the product on the ground with your
left hand. Do not put your feet on the product.
4. Pull the starter rope handle slowly until you feel
some resistance, then pull the starter rope handle
with force.
WARNING:
rope around your hand.
5. Continue to pull the starter rope handle until the
engine starts.
CAUTION:
rope to full extension and do not let go
of the starter rope handle. Release the
starter rope slowly to prevent damage to
the product.
6. When the engine starts, put the choke control in the
run position and apply full throttle. The throttle trigger
automatically disengages from the start position.
7. Make sure that the engine operates smoothly.
WARNING:
with a damaged spark plug cap to prevent
electrical shock.
1173 - 005 - 30.08.2023
Do not wind the starter
Do not pull the starter
Do not use the product
To prepare a warm engine for start
1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Pull the starter rope handle until the engine starts.
Push the throttle trigger slowly to increase the speed
gradually.
CAUTION:
rope to full extension. Do not let go of
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
To stop the product
1. Move the stop switch into the stop position to stop
the engine.
CAUTION:
automatically goes back to its initial
position. In order to prevent accidental
starting, the spark plug cap must
be removed from the spark plug
when assembling, checking and/or
maintenance is done.
Do not pull the starter
The stop switch
11