Publicidad
Idiomas disponibles
Idiomas disponibles
COLD
WEATHER
STARTING
( 50 ° F and
below)
7.
When
engine
starts,
leave throttle
control
in choke
position
until engine
warms
up and begins
to run roughly.
Once
rough running
begins,
immedi-
ately move the throttle
control
to the
fast position.
Engine
warm-up
may
take from several
seconds
to several
minutes
(the colder
the temperature,
the longer
the warm-up).
• The attachments
can also be used dur-
ing the engine
warm-up
period.
NOTE:
If at a high altitude
(above
3000
feet) or in cold temperatures
(below
32 F)
the carburetor
fuel mixture
may need to
be adjusted
for best engine
performance
(see "TO ADJUST
CARBURETOR"
in the
Service
and Adjustments
section
of this
manual).
MOWING TIPS
• Mower
should
be properly
leveled
for
best mowing
performance.
See "TO
LEVEL
MOWER
HOUSING"
in the
Service
and Adjustments
section
of this
manual.
• The left hand side of mower
should
be
used for trimming.
• Drive so that clippings
are discharged
onto the area that has already
been
cut.
Have the cut area to the right of
the tractor.
This will result
in a more
even
distribution
of clippings
and more
uniform
cutting.
• When
mowing
large areas,
start by
turning
to the right so that clippings
will
discharge
away from shrubs,
fences,
driveways,
etc.
After
one or two rounds,
mow in the opposite
direction
making
left hand turns
until finished.
f
,[
J
00272
If grass
is extremely
tall, it should
be
mowed
twice
to reduce
load and pos-
sible fire hazard
from dried clippings.
Make first cut relatively
high; the second
to the desired
height.
Do not mow grass
when
it is wet.
Wet grass
will plug mower
and leave
undesirable
clumps.
Allow
grass to dry
before
mowing.
Always
operate
engine
at full throttle
when
mowing
to assure
better
mowing
performance
and proper
discharge
of
material.
Regulate
ground
speed
by
selecting
a low enough
gear to give the
mower
cutting
performance
as well as
the quality
of cut desired.
When
operating
attachments,
select
a
ground
speed
that will suit the terrain
and give best performance
of the at-
tachment
being
used.
16
Publicidad
