Publicidad
Idiomas disponibles
Idiomas disponibles
Your new tractor has been assembled at the factory with the exception of those parts
left unassembledfor shipping purposes. Toensure safe and proper operationof your
tractor all parts and hardware you assemble must be tightened securely. Use the correct
tools as necessary to insure proper tightness.
TOOLS
REQUIRED
FOR
ASSEMBLY
A socket
wrench
set will make assembly
easier.
Standard
wrench
sizes
you need
are listed below.
(1) 3/4" wrench
(1)
Pliers
(1)
1/2" wrench
(1)
Utility knife
(1) Tire
pressure
gauge
When right or left hand is mentioned in
this manual, it means when you are in
the operating position (seated behind the
steering wheel).
TO REMOVE TRACTOR
FROM
CARTON
UNPACK CARTON
1.
Remove
all accessible
loose
parts and
parts boxes
from carton.
2.
Cut along dashed
lines on all four pan-
els of carton.
Remove
end panels
and
lay side panels
flat.
3.
Check
for any additional
loose
parts or
cartons
and remove.
BEFORE
REMOVING
TRACTOR
FROM
SKID
ATTACH STEERING
WHEEL
ASSEMBLE
EXTENSION
SHAFT AND
BOOT
1. Slide extension shaft onto lower steer-
ing shaft.
2. Place tabs of steering boot over tab
slots in dash and push down to secure.
INSTALL
STEERING
WHEEL
3.
Position
front wheels
of the tractor
so
they are pointing
straight
forward.
4.
Remove
steering
wheel
adapter
from
steering
wheel
and slide adapter
onto
steering
shaft
extension.
5.
Position
steering
wheel
so cross
bars
are horizontal
(left to right)
and slide
inside
boot and onto adapter.
6.
Assemble
large flat washer,
5/16 lock
washer,
5/16
hex bolt and tighten
securely.
7.
Snap steering
wheel
insert into center
of steering
wheel.
8.
Remove
protective
materials
from trac-
tor hood and grill.
IMPORTANT:
Check
for and remove
any
staples
in skid that may puncture
tires
where
tractor
is to roll off skid.
Insert
_
_
5/16 Hex Bolt
J
_
/5/16
Lock
Washer
'
Large Fiat
_
Washer
Steering
_/f,_----_
/
Wheel _/
___/
Steering
Boot
Tabs---___L_, ,_[_;
Adapter
Extension
Slots
8
Publicidad
