Publicidad
Idiomas disponibles
Idiomas disponibles
BELT INSTALLATION-
1.
Work
belt around
both mandrel
pulleys
and idler pulleys
2.
Make sure belt is in all pulley
grooves
and inside
all belt guides.
3.
Install
mower
(See "To Install
Mower"
in this section
of this manual).
Mandrel
Idler Pulleys
Pulley
TO CHECK BRAKE
If tractor
requires
more than five (5) feet to
stop at highest
speed
in highest
gear on a
level,
dry concrete
or paved
surface,
then
brake
must
be serviced.
You may also check
brake
by:
1.
Park tractor
on a level,
dry concrete
or
paved
surface,
depress
clutch/brake
pedal
all the
way
down
and
engage
parking
brake.
2.
Place gear shift lever in neutral
position.
The
rear wheels
must
lock and skid when
you try to manually
push the tractor
forward.
If the
rear wheels
rotate,
then
the
brake
needs
to be serviced.
Contact
a Sears
or
other
qualified
service
center.
TO REPLACE
MOTION DRIVE BELT
Park the tractor
on level
surface.
Engage
parking
brake.
For assistance,
there
is a
belt installation
guide
decal
on bottom
side
of left footrest.
BELT REMOVAL-
1.
Remove
mower
(See
"TO
REMOVE
MOWER"
in this section
of manual).
NOTE:
Observe
entire
motion drive belt and
position
of all belt guides
and keepers.
2.
Remove
belt from
stationary
idler and
clutching
idler.
3.
Remove
belt
downward
from
around
engine
pulley.
4.
Pull
belt
slack
toward
rear
of tractor.
Remove
belt
upwards
from
transaxle
pulley
by deflecting
belt keepers.
5.
Remove
belt from
center
span
keeper
and pull belt away from tractor.
23
BELT INSTALLATION
-
1.
Carefully
work
new belt down
between
transaxle
belt keepers
and onto the input
pulley.
2.
Slide belt into the center
span
keeper.
3.
Pull belt toward
front
of tractor
and roll
around
the top groove
of engine
pulley.
4.
Install
belt through
stationary
idler and
clutching
idler.
5.
Make
sure
belt is in all pulley
grooves
and inside
all belt guides
and keepers.
6.
Install
mower
(See "TO INSTALL
MOW-
ER" in this section
of manual).
Engine Pulley
Clutching
Center
_Span
Keeper
Stationary Idler
Transaxle
TRANSAXLE
GEAR
SHIFT
LEVER
NEU-
TRAL
ADJUSTMENT
The transaxle
should
be in neutral
when
the gear shift lever
is in neutral
(lock gate)
position.
The adjustment
is preset
at the
factory;
however,
if adjustment
is needed,
proceed
as follows:
1.
Make sure transaxle
is in neutral.
NOTE:
When
the tractor
rear wheels
move freely,
the transaxle
is in neutral.
2.
Loosen
adjustment
bolt in front of the
right rear wheel.
3.
Position
the gear shift lever in the neu-
tral position.
4.
Tighten
adjustment
bolt securely.
NOTE:
If additional
clearance
is needed
to get to adjustment
bolt, move
mower
deck
height
to the lowest
position.
Publicidad
