cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 144

ENGLISH
remain in the drum and drainage system. Run a "Drum Clean" cycle without laundry to
clean the system before your first load of laundry.
First add 1 or 2 tablespoons of detergent to compartment I of the detergent dispenser.
Then run the "Drum Clean" cycle.
Wait for the cycle to finish.
How to use the washer dryer
1. Load the laundry
Open the door and insert the laundry into the drum. Load the items one at a time without
squeezing them or overfilling the drum, place them evenly. Please note the load sizes
indicated in the "Washing cycle table". Overloading of the machine will result in non-optimal
washing and wrinkled laundry.
2. Close the door
Make sure that there are no dirty clothes between the door glass and the rubber seal. Close
the door, make sure you hear the "click" as it closes.
3. Open the tap
Make sure that the appliance is connected to the water mains. Open the tap.
4. Set the desired programme
Select the required programme with the washing programme selector. The duration of
the wash cycle is shown on the display. The machine automatically displays the default
temperature and possible spin speed settings for the selected programme. Adjust the
temperature and/or spin speed settings, if necessary, with the corresponding buttons.
Change the temperature, if necessary
Press the TEMP (Temperature) button to progressively decrease the temperature setting until
cold wash is reached ("--" will be displayed on the digital display). Pressing the button again
sets the highest possible setting.
Change the spin speed, if necessary
Press the "SPEED" button to progressively decrease the spin speed until the spin cycle is
switched off ("--" will be shown on the digital display). Pressing the button again sets the
highest possible setting.
Select options, if necessary
144 BOLERO WASH&DRY 10680 INVERTER B / STEEL B