cecotec BOLERO WASH&DRY 10680 INVERTER B Manual De Instrucciones página 154

ENGLISH
After drying, there are drops
of water on the door and
drum
The drying effect is poor and
uneven.
General issues
- Do not repair or replace any part of the appliance unless specifically instructed to do
so in this instruction manual. It may lead to a dangerous incident that endangers your
health and/or damages property.
- In case of fault or malfunction, contact the official Technical Support Service of Cecotec.
- Use original spare parts.
- IMPORTANT: Do not come into contact with the following internal components while the
appliance is connected: inlet valve(s), drain pump, motor controller heat sink, PCB.
154 BOLERO WASH&DRY 10680 INVERTER B / STEEL B
During drying, the door may be stained with water droplets,
wipe off the water droplets.
Do you wear too much or too thick clothing?
Do clothes that are not easy to dry (such as thick cotton
fabrics) and fabrics that are easy to dry (such as synthetic
fabrics) dry together?
Do you put too many laundries to dry?
When only running the "Drying" programme, do you separate
the tangled laundry to place it in the drum?
Due to different types and quantities of laundry, uneven drying
l
may occur. Is the tap closed during drying?
Is the drain pump filter blocked during drying?
Is the drain hose bent, kinked or blocked during drying?
Your appliance contains sensors that monitor progress during
the wash cycle (e.g. water level, temperature, unbalanced
loads, wash time/progress). Normally, if your appliance
completes the cycle successfully, it is unlikely that there will
be a problem.