Publicidad
Idiomas disponibles
Idiomas disponibles
REplaciNg thE cooliNg uNit
!
This operation should noT be attempted by
someone not properly trained to perform
technical service.
1
Make sure that the replacement cooling unit is correct
for the refrigerator.
Remove the capillary tube from the cooling element and
2
pull it carefully out of the rear of the cabinet.
!
BE CAREFUl noT To BREAk THE TUBE!
Look for screws holding cooling elements inside the
3
refrigerator and remove them,
4
Remove the door handles and carefully lay
down the refrigerator on the doors.
5
Remove the electric heater.
6
Carefully remove the gas assembly from the
cooling unit.
7
Look for screws holding the cooling unit to the cabinet
back and remove them.
Look for sealing tape possibly applied between the cool-
8
ing unit and the cabinet back. Remove if any.
Carefully pull the cooling unit out from the cabinet. If it is
9
hard to get out, apply a lever.
10
Remove all residual foam on the back of the refrigerator
that may be left from the old cooling unit.
Wood block between
lever and topmost
cooling unit pipe
www.sibir.com
!
Before condemning a cooling unit:
· Shut the gas valve at the gas bottle and
· Turn the empty refrigerator upside down a
· Make sure that instructions for installation,
· If the refrigerator works using electricity but
9
!
BE CAREFUl noT To BREAk Any CoolInG UnIT PIPES!
3
disconnect the gas supply line, and pull out
the plug from the wall socket.
few times and see if it works when started.
use, maintenance and fault finding have
been followed.
not with gas, or the other way around, the
cooling unit is noT faulty.
Slide steel plate under
the pipe coils as protection
13
copyright © sibir international
Publicidad
