SKYLOTEC RESC B Instrucciones De Uso página 9

ATTENTION! For safe use, always use all three loops of one colour
together!
8.) Safety requirements
The instructions must be strictly observed for the protection of the
user and the equipment! The product labelling must be completely
legible! To avoid suspension trauma, an emergency plan must be in
place to keep the suspension time in the harness or loop as short
as possible, thus preventing a circulatory collapse. There is an
essential need for the user to check all attachment and/or
adjustment parts regularly during use.
• Application temperature -35 to +45°C
• Store and transport dry and protected from light
• Avoid slack rope
• Avoid contact with aggressive substances
• Observe danger from suspension trauma
• Observe danger from edges and rough surfaces
• Observe danger from electrical equipment
• Observe danger from moving machine parts
• Do not wear PPE in areas where there is a risk of falling.
• Avoid heat and flames.
Warning! If the rescue harness / rescue loop is used together with
or in addition to a fall arrest system, the instructions for the
corresponding components must be read and observed (e.g.
position of the anchor point, attachment to the anchor point,
required clearance below the user).
Note: In a fall arrest system, only a full body harness (EN 361) can
be used as body holding device!
9.) Changes, repairs
Any changes or additions must not be made by the user, but
exclusively by SKYLOTEC.
Any repairs of damaged and/or defective components are
prohibited!
10.) Lifetime
The max. service life (period between production date and discard
date) results from the storage period before delivery to the end
consumer and the period of use.
With the storage period of max. 2 years before delivery to the end
user or before purchase, it should be noted that the products are
-stored without extreme temperature fluctuations,
-protected from UV radiation, moisture, chemicals and harmful/
aggressive environmental conditions, and
-stored in the original undamaged packaging.
The service life begins with the delivery to the end user and is max.
10 years. After delivery to the end user (proof by e.g. purchase
receipt/delivery note with serial/batch number), regular inspection
by a competent person is required at least once a year. In addition,
the respective country-specific regulations must be observed,
which may prescribe shorter periods.
MAT-BA-0020-01.indd 9 MAT-BA-0020-01.indd 9
9 9
20.04.2023 12:01:11 20.04.2023 12:01:11