AQUA SPHERE ECO IVS Serie Manual De Instrucciones página 10

4.5 Application conditions
Ambient temperature
Water temperature
Maximum water salt level
Humidity
Altitude
Installation
Insulation
5. SETTING AND OPERATION
5.1 Display on control panel:
5.2 Startup:
When the power is switched on, the screen will be fully light for 3 seconds, the device code
will be displayed, and then it will enter the normal working state. When the screen is locked,
only the button is lit; Press and hold
will all light up. The screen will automatically lock up when there is no operation for more than
1 minute and the brightness of the screen is reduced by 1/3 of the normal display. Short press
to wake up the screen and observe the relevant operating parameters.
5.3 Self-priming
When switched on for the first time after installation, the pump will start self-priming auto-
matically.
The system is self-priming. It will count down from 1500s and stop automatically when the
system detects the pump is full of water, then the system will recheck for 30s again to make
sure the self-priming is completed.
The user can exit the self-priming mode manually by pressing
run at the default 80% speed on initial startup. If the user exits the self-priming mode in the subsequent startup,
the pump will return to its previous status before the last shutdown.
Indoor installation, temperature range: -10-40ºC
5 ºC-40ºC
5 g/l (5000 ppm)
≤90% RH, (20 ºC±2ºC)
Not exceed 1000m above sea level
The pump can be installed max. 2m above water level
Class F, IPX5
Power consumption/power display
1
Running capacity/power indicator
2
Timer indicator 1/2/3/4
3
Unlock
Up/down: to change the value of the setting
Timer setting
On/off
for more than 3 seconds to unlock, other buttons
10
for more than 3 seconds. The pump will