AQUA SPHERE ECO IVS Serie Manual De Instrucciones página 13

5.7 Parameter Setting
Restore factory setting
Check the software
version
Manual priming
Enter parameter set- ting
as below
Parameter
Description
Address
1
2
3
4
Enable or disable the
5 priming that occurs at
each start
Under OFF mode, hold both
Under OFF mode, hold both
Under ON mode, hold both
Under the OFF mode, press both
The parameter value (on the left) and default setting value (on the right) will flash
alternately on the screen. Users should press
value, and press both
value. It will exit the parameter setting after 10 seconds without operating.
Default Setting
PIN3 100%
PIN2 80%
PIN1 40%
Backwash
capacity
and for 3 seconds
and for 3 seconds
and for 3 seconds
and for 3 seconds to enter the setting.
and for 3 seconds to go to the next parameter
30-100%, by 5% increments
30-100%, by 5% increments
30-100%, by 5% increments
100%
25 25:enables / 0: disables
13
or to adjust the current
Setting Range
80-100%, by 5% increments