AQUA SPHERE ECO IVS Serie Manual De Instrucciones página 12

5.6 Timer mode
The pump's on/off and running capacity could be commanded by timer, which could be pro-
grammed daily as needed.
1
Enter timer setting by pressing
2
Press or to set the local time. Press
3 When entering the timer-1 setting, the timer indicator 1 will light up. "StA"will be shown on the screen. Press
to proceed and then press
each step). Press
4
When the start time of timer 1 is confirmed, "End" will be shown on the screen.
Press to proceed and then press
for each step). Press
5
When the end time of timer 1 is confirmed, "SPd" will be shown on the screen. Press
press or to set the running capacity of timer-1 (30%–100%; each step increases or decreases by 5%).
Press to confirm.
6
When the timer 1 setting has been completed, repeat steps 3–5 to complete the settings of timers 2–4.
Note:
When the timer mode is activated, if the set time contains the current time, the pump will start running
according to the set running capacity and the corresponding timer indicator (1 or 2 or 3 or 4) will stay
on, and the set running capacity will be shown on the screen.
If the set time does not contain the current time, the timer indicator (1 or 2 or 3 or 4) that is about to
start running will light up and flash, and the current time will be shown on the screen.
During the timer setting, if users want to return to the previous setting item, they should press both
and for 3 seconds. If users do not need the 4 timers, they should press
completing the setup of the specific timer. The system will automatically save the current value and
activate the timer mode.
When the timer mode is on, users can check the settings of each timer. Press
timer (1 or 2 or 3 or 4), and the corresponding timer indicator will light up. Then press
start time, end time and running capacity setting of the timer selected.
Users should press for 3 seconds to read the real-time power capacity and it will return to the timer
display after 10s without operating. Users can exit the timer mode by pressing
to confirm and move to the timer-1 setting
or to set the start time of timer-1 (30-minute increase or decrease for
to confirm.
or
to confirm.
to set the end time of timer-1 (30-minute increase or decrease
12
to proceed and then
for 3 seconds after
to select a specific
to check the
for 3 seconds.