Motorola Solutions IMPRES 2 Guia Del Usuario página 24

MN002407A01-AK
Chapter 4: Charger Overview
Figure 2: Charging Battery Attached to Radio
Figure 3: Charging Standalone Battery
4.3
Charging USB Accessories
Some IMPRES 2 Multi-Unit Charger Communications Modules provide USB Type-A sockets to charge USB
accessories. USB accessories charge best at room temperature.
Procedure:
1. Place the IMPRES 2 Adaptive Charger on a flat surface.
2. Firmly insert the power cord into the charger AC Socket on the back of the charger.
3. Plug the power cord into a matching power outlet.
4. Upon successful power-up, each pocket Status LED flashes Green for 1 second and IMPRES 2
CHARGER is displayed. If the Status LEDs do not flash and no message is displayed, check power
cord connections.
5. A USB accessory can have one Micro-AB receptacle for charging. Use a standard 1 meter or shorter
USB cable with a Type A plug on one end and an accessory-compatible plug on the other end
(typically Micro-B or Micro-AB).
6. Adjust the USB cable Type A plug to align properly with a Type A port on the Communications
Module. Insert the plug into the port.
7. Adjust the USB cable Micro-B plug to align properly with the Micro-AB receptacle on the USB
accessory. Insert the plug into the receptacle.
8. When the USB connections are properly seated, the charging status is indicated by the USB
accessory. Refer to the USB accessory User Guide for details.
24