Sony UPX-DP10 Manual De Instrucciones página 71

DARK adjustment (D parameter)
Adjust dark areas. The default is 0.
g
Press the key to change the parameter in the +
direction, i.e., 1, 2, 3, ... 7. The dark side of each of the
RGB elements is linearly amplified, giving depth to
the picture. The darkest point is 0; it is the point of
saturation.
G
Press the key to change the parameter in the -
direction, i.e., -1, -2, -3, ... -7. The dark side of each
of the RGB elements brightens, and the picture loses
depth.
Correspondence between parameter values
and picture quality
Bright
192
After
128
change
64
0
0 64
Dark
LIGHT adjustment (L parameter)
Adjust bright areas. The default is 0.
g
Press the key , and the R, G, and B parameters
change simultaneously; the bright side of each of the
RGB elements is linearly amplified, and the resultant
picture should look somewhat overexposed.
G
Press the key to darken the bright side of each of the
RGB elements. The resultant picture should look
somewhat underexposed.
SHARPNESS adjustment
Adjust the sharpness of the picture. The default is
LOW.
There are four options: NONE, LOW, MIDDLE, and
HIGH. LOW is recommended when the printout is to
have many split sections.
- 7
+7
128 192
Bright
Subject
GAMMA adjustment (Gm parameter)
Adjust the gamma value. The default is 0.
g
Press the key to amplify the half tone of each of the
RGB elements towards the bright side.
G
Press the key to attenuate the half tone of each of
the RGB elements towards the dark side.
GRAY adjustment
The default is 0. This item is enabled only when B/W
mode is selected. This item is not available in some
special models.
The adjustment is valid only when color ribbons are
used.
g
Press the key to weaken yellowness and increase
blueness.
G
Press the key to increase yellowness.
71