Publicidad
Idiomas disponibles
Idiomas disponibles
6 – TROUBLE SHOOTING-GUIDE
PROBLEM
The system does not operate
when the reverse gear is
engaged
Always indicating an obstacle
No audio alarm when the
obstacle is in the detection
range
False alarm
7 – IMPORTANT NOTICE
1 - The GT Parking Sensor is strictly a driver aid when parking or reversing your vehicle.
Not all objects will be detected by your sensors, therefore you must exercise caution and
common sense when reversing your vehicle.
2 - Reverse your vehicle at a speed lower than 6km/h for safety reason.
3 - Always stop your vehicle when you obtain a continuous beep.
4 - Carry out regular checks on your sensors and always keep them cleaned.
5 - If water drops on the sensor surface (i.e. washing, raining, etc.), the sensitivity could
decrease 20%.
6 - Keep all the cables and the sensors away from the high temperature objects such as
the engine or exhaust pipes which can damage the system.
7 - The design of the GT Parking Sensor is very complicated, opening by user may damage
it's components. The manufacturer shall refuse any warranty claim if the system has been
tampered by the user.
8 - Product Origin: China.
8 – WARRANTY CONDITION
- The product is covered by a 24-months warranty from the purchase date, which is certified by
receipt or invoice.
In order to benefit from the warranty, it is necessary to contact the authorized seller / installer and
show the proof of purchase with the relative date.
- During the warranty period, if a dissimilarity in relation to the features and performances declared by
the manufacturer is ascertained and recognized, the purchaser should report the defect to the seller /
installer within two months from the date on which he discovered the defect.
REASON
Wrong connection of the the device
power supply
Incorrect connection of the plugs
The sensor is detecting the ground
The BUZZER is switched OFF
Incorrect connection of the sensors
The sensor is detecting the ground
The system sensitivity is too high
SOLUTION
Verifiche di alimentazione
Reconnect all plugs
Check the sensors position
Reset the system
Reset the system and check the
sensor position
Reconnect the sensors
Ask to your installer to adjust
the sensitivity
7
Publicidad
