Etac Molift RgoSling StandUp Manual Del Usuario página 12

Slings
Always check – before each use:
• that the user has the required ability for the
sling.
• that the model, size and fabric are suitable for
the user and the transfer situation.
• that the sling is suitable for the hoist and the
sling bar.
• that the sling does not have visible damage or
frays to seams, fabric, straps and loops.
• that the loop connections are correctly attached
to the sling bar hooks before hoisting the user.
• that the wheels on the wheelchair or bed are
locked during the transfer. If using a mobile hoist
the wheels on the hoist must not be locked.
If the inspection reveals any safety risks, the
sling must immediately be taken out of ser-
vice and be disposed of.
Never use a faulty or damaged sling as it can
break and cause personal injury. Destroy
and discard damaged and old slings.
Troubleshooting
Problem
There is more than 10 cm between the left and
right side padding of the waist belt.
The waist belt is too loose after tightening it.
The sling is sliding up.
The user is not able to take load on the legs.
The ropes are not loaded at the same time.
EN
Materials
All used materials which are to be in direct contact
with skin are biologically assessed and evaluated
according to relevant standards. However, users/
carers who are allergic to any of the materials are
recommend not to use the device.
Accessories
User manuals supplied with accessories must
be read and understood before use. This in-
cludes any limitations in use and combinations.
Information about accessories can be found on
www.etac.com.
Combinations
This device can be combined with Molift sling bars
and hoists. See the combination list on page 58.
Statement on sling and hoist compatibility for
other manufactures of hoists can be found on
www.etac.com.
When combining the device with other devices,
the combination must not change the intended
purpose of the devices or modify the devices in
such a way that compliance with the applicable re-
quirements may be affected. The person/compa-
ny responsible for the combination of the devices
must ensure that the applicable requirements are
fulfilled.
If safe working load (SWL) differs between
hoist, sling bar and sling, the lowest load
should always be used.
Action
Try a larger size.
Try a smaller size.
Tighten the waist belt properly.
Make sure the sling is positioned low enough on
the user's back when applying it.
Make sure the user leans backwards when hoist-
ing. Otherwise, evaluate whether the user is able to
follow the instructions or requires a passive hoist.
Make sure the user is not wearing slippery clothes.
Evaluate whether the user has the physical ability
for this type of sling. Otherwise, the user requires a
passive hoist.
Make sure the ropes are attached symmetrically.
Make sure the centre of the sling is at the midline
of the user.
12
etac.com