Publicidad
Idiomas disponibles
Idiomas disponibles
defined PIR settings.
First, you have to set the start and stop times for the time frame (for
example 19:00 to 07:00 the next day). And then you have to set the
interval of time between each still image. The camera will remain in
Time Lapse mode until you change the program setting. The image
resolution and burst number are the same as in PIR mode.
•
Slide the switch to the TEST position from OFF, the status
display will show the camera current status.
•
Press the [M] button once to enter the programming mode, the
word "PIR" or "TLS" will be blinking.
•
Press the DOWN [▼] button until you see
the word "TLS" blinking.
•
Press [M] to confirm.
•
The display will show T + S 88:88
(S = Start, 88:88 = time in HH:MM). You can
adjust the start time from 00:00 to 23:59.
•
Press [M] to enter the "Start Time" setting.
•
The hours 1
[▲] or DOWN [▼] button to increase or
decrease the value then press [M] once to confirm and move to
the next digit setting.
•
The hours 2
button to increase or decrease the value then press [M] once to
confirm and move to the next digit setting.
•
The minutes 1
button to increase or decrease the value then press [M] once to
confirm and move to the last digit setting.
•
The minutes 2
button to increase or decrease the value than
press [M] once to confirm the Start Time
setting and move to the End Time setting.
•
The
display
Indice A
st
digit is blinking. Press the UP
nd
digit is blinking. Press the UP [▲] or DOWN [▼]
st
digit is blinking. Press the UP [▲] or DOWN [▼]
nd
digit is blinking. Press the UP [▲] or DOWN [▼]
will
show
T
+
E
88:88
42/144
Publicidad
