Num'axes PIE 1013 Manual De Instrucciones página 44

#3: If a user selects the Time Lapse mode, and sets the Start Time at
00:00 and End Time at 00:00, then selects the Time Out to be 5 minutes
with a Burst mode of 3 pictures, this means the camera will take 3
pictures every 5 minutes, 24 hours a day non-stop.
Time Lapse Mode Setup recommendations
If you are using the Time Lapse feature and want to extend the battery
life and get as many pictures as possible, we recommend you use the
following settings:
Batteries: lithium batteries
Image resolution: 1 star (2MP)
Time Out: more than 30 seconds
Setting the Time and Date in PIR detection mode or Time
Lapse mode
Your camera uses the 24-hour military time format.
•
Slide the switch to the TEST position, the status display will
show the camera current status.
•
Press the [M] button once to enter the programming mode.
•
The word "PIR" or "TLS" will be blinking, press the DOWN [▼]
button until the word "SEt" is blinking then press [M] once to
confirm you want to enter the setting.
•
The word "-dEL-" is blinking on the LCD
screen, press the DOWN [▼] button once.
•
The letter "T" (Time) is blinking. Press the
[M] button once to enter the time setting
(HH:MM).
•
The hours 1
button to increase or decrease the value then press [M] once to
confirm and move to the next digit setting.
•
The hours 2
button to increase or decrease the value then press [M] once to
confirm and move to the next digit setting.
•
The minutes 1
Indice A
st
digit is blinking. Press the UP [▲] or DOWN [▼]
nd
digit is blinking. Press the UP [▲] or DOWN [▼]
st
digit is blinking. Press the UP [▲] or DOWN [▼]
44/144