Num'axes PIE 1013 Manual De Instrucciones página 49

camera into the proper mode.
To capture images, make sure display reads CAM:
Once in MAN mode, if the display does not read CAM then:
•
Slide the switch to the TEST position, the status display will
show the camera current status.
•
Press the [M] button once to enter the programming mode.
•
The word "PIR" will be blinking, press [M] once to confirm the
camera's operation is PIR detection.
•
Press the UP [▲] or DOWN [▼] button until the word "CAM" is
blinking.
•
Press the [M] button once to confirm and then press and hold
the [M] button for 2 seconds to exit.
•
Then slide the switch from the TEST position to MAN and close
the cover.
To capture videos, make sure display reads VIDEO:
Once in MAN mode, if the display does not read VIDEO then:
•
Slide the switch to the TEST position, the status display will
show the camera current status.
•
Press the [M] button once to enter the programming mode.
•
The word "PIR" will be blinking, press [M] once to confirm the
camera's operation is PIR detection.
•
Press the UP [▲] or DOWN [▼] button until the word "VIDEO"
is blinking.
•
Press the [M] button once to confirm and then press and hold
the [M] button for 2 seconds to exit.
•
Then slide the switch from the TEST position to MAN, and close
the cover.
Now, the status display will count down 60 seconds for you to leave the
coverage area and then the camera will capture images or videos at
each PIR triggering.
NOTE: The time between motion detection and the camera
taking the pictures may vary due to lighting conditions,
Indice A 49/144