Publicidad
Idiomas disponibles
Idiomas disponibles
•
Avoid accidental start-up Make sure that the switch
is in the OFF position before plugging in
•
Do not force tool It will work most efficiently at the
rate for which it was designed
•
Keep hands away from moving parts and cutting
surfaces.
•
Never leave tool running unattended. Turn the power
off and do not leave tool until it comes to a complete
stop.
•
Do not overreach. Keep proper footing and balance.
•
Never stand on tool. Serious injury could occur if tool is
tipped or if blade is unintentionally contacted.
•
Know your tool. Learn the tool's operation, applica-
tion and specific limitations.
•
Use recommended
accessories (refer to page 13).
Use of improper accessories
may cause risk of
injury to persons.
•
Handle workpiece correctly. Protect hands from pos-
sible injury.
•
Turn machine off if it jams. Blade jams when it digs
too deeply into workpiece. (Motor force keeps it
stuck in the work.)
•
Always keep drive, cutterhead and blade guards in
place and in proper operating condition.
•
Feed work into blade or cutter against direction of
rotation.
CAUTION:
Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING:
Do not attempt to operate tool until it is
completely assembled according to the instructions.
Refer to Figure 1 below
Check for shipping damage
If damage has occurred, a
claim must be filed with carrier Check for complete-
ness Immediately report missing or damaged parts
Call 1-800-266-9079 to obtain replacement parts
The jointer/planer is shipped complete in one carton
Additional parts which need to be fastened to joint-
er/planer should be located and accounted for before
assembling
A
Jointer
B
Fence Assembly
C
Fence Bracket Assembly
D
Push Blocks (2)
Hardware bag includes:
•
M6 x 20mm Socket Pan Head Screws (4)
•
6mm Lock washer (8)
•
Mounting Bracket (4)
•
M6 x 12mm Socket Pan Head Screws (4)
•
Magnet
•
Switch Key
•
3mm Hex Wrench
•
4mm Hex Wrench
A
C
Figure 1 - Unpacking
Refer to Figures 2 and 3.
D
ATTACH FENCE ASSEMBLY
Attach fence bracket assemblies to fence using four
M6 x 20 screws and lock washers. There is a right
side and a left side bracket assembly. See Figure 2
for correct installation. Do not completely tighten
screws
Attach fence assembly to jointer bed using four M6 x
12 screws and lock washers (B) Pull blade guard
back so that fence can be properly fitted to jointer
(see Figure 3)
Completely tighten all screws Secure fence in posi-
tion with locking handles (C)See
Figure 2
Figure 2 - Attach Fence Assembly
Figure 3 - Swing Blade Guard Back to Install Fence
3
Publicidad
