Balluff BTL AK5A00-0930-C11WH120-000C51-001 Manual De Instrucciones página 35

BTL AK _ A00- _ _ _ _ -C11WH120-000C51-001
Magnetostrictive Linear Position Sensor – Rod Style
5
Installation and connection (continued)
5.1.3 Installation notes
Hydraulic cylinder: If installed in a hydraulic cylinder, the
magnet should not make contact with the rod. Minimum
bore diameter in the support piston:
Rod diameter
10.2 mm
Tab. 5-1: Bore diameter if installed in a hydraulic cylinder
Bore hole: The contact surface of the sensor housing
must be in full contact with the mounting surface. A
suitable O-ring (ISO 3601 14 x 2) must completely seal the
bore, i.e. the countersink for the O-ring must be produced
according to Fig. 5-4.
+0.1
Ø 30
0.0
H7 +0.018
Ø 18
0.000
Fig. 5-4: Mounting hole for installing the BTL with O-ring
Horizontal mounting: For horizontal mounting with
measuring lengths > 500 mm, support the rod and, if
necessary, screw it on at the end (with threaded rod end).
Magnet: Various magnets are available for the BTL (see
Accessories on page 21).
www.balluff.com
Bore diameter D2
At least 13 mm
2.5×45°
0.7×25°
english 11