Publicidad
Idiomas disponibles
Idiomas disponibles
SOLVING PROBLEMS AND ERROR CODES
Problem
The ceramic hob
does not turn on
Touch buttons do not
work
Touch buttons do
not work properly
The surface of the
plate is scratched
E1
The voltage is very low <130 V ~ AC
E2
E3 y E8
Et
INSTALLATION
Drill a hole in the worktop based on the following suggestions:
It must leave at least a minimum of 5 cm around the hole, free of obstacles
(furniture, appliances, etc.).
The thickness of the worktop is at least 30 mm.
Choose the material of the worktop that is heat resistant to avoid
deformation caused by heat radiation from the ceramic hob.
L(mm)
W(mm)
590
Possible causes
No mains power
The control panel is
locked
There is water or liquid
on the buttons or you
may be using the tip of
your finger when
touching the buttons.
Cookware can have
edges or edges that
will deteriorate the
hob.
The voltage is too high> 260V ~ AC
Sensor or control circuit failure
Dirty control panel
H(mm)
520
58
Make sure that the hob is connected to the
mains socket and that the switch o is in the on
position. Check if you have light in the rest of
your house. If you have checked everything
and the problem persists, call a technician.
Unlock the control panel, see the
corresponding section.
Make sure the control panel area is clean and
dry. Use the pad of your finger when touching
Use cookware with a flat, smooth bottom.
The utensils or cleaning products used are not
Remove liquid residue from the
D(mm)
A(mm)
54
565
15
What to do?
the controls.
adequate.
Consult a qualified electrician
Consult a qualified electrician
Contact the Official Technical
Service
control panel l
B(mm)
495
X(mm)
50 min.
Publicidad
