Husqvarna DP110 Manual De Usuario página 15

Note:
The saw chain has the correct tension when
it does not hang down from the bottom of the guide
bar, but is easily turned by hand.(Fig. 27)
11. Hold up the front of the guide bar and tighten the
locking knob.
Note:
When you install a new saw chain, do a run-
in and examine the chain tension frequently during
that period. Examine the chain tension regularly. A
chain that has correct tension is necessary for good
cutting performance and long saw chain life.
To install the handguard
1. Unfold the handguard clamp and put it on the shaft.
Make sure that the tab on the shaft is in the groove
on the bottom of the handguard clamp. (Fig. 28)
2. Fold the handguard clamp around the shaft and
tighten the 2 screws.
To adjust the harness
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is approximately level with your right hip. (Fig.
17)
To fill the chain oil tank with chain oil
1. Remove the oil tank cap from the chain oil tank. (Fig.
29)
Introduction
WARNING:
safety chapter before you use the product.
To do before you start the product
1. Do an inspection of the work area. Remove objects
that can be thrown out.
2. Do a check of the cutting attachment. Do not use
blunt or damaged equipment.
3. Make sure that the product operates correctly.
4. Make sure that all nuts and screws are tight.
5. Make sure that the lubrication for the chain operates
To lubricate cutting equipment on
correctly. Refer to
page 18 .
6. Make sure that the cutting attachment always stops
when you release the power trigger.
7. Only use the product to cut branches and twigs.
2195 - 006 - 26.10.2023
Operation
Read and understand the
2. Fill the tank with saw chain oil.
3. Tighten the oil tank cap.
To install the storage hook on the wall
• Install the storage hook indoors.
• Keep the storage hook out of sunlight and in ambient
temperature of -10°C to 70°C.
• Install the storage hook on a drywall, wood or
concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
• Install the storage hook on the wall with the 3 screws
(A). Use wall plugs (B) if it is necessary. (Fig. 30)
CAUTION:
screws are applicable for your wall type.
• Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
To hang the pole saw attachment on
the storage hook
• Hang the pole saw attachment on the storage hook
as shown in the illustration. (Fig. 31)
8. Make sure that the handle and safety functions are
not damaged and operate correctly. Do not use a
product that has missing parts or is changed from its
specification.
9. Make sure that the locking devices of movable
elements, for example the extended shaft and
pivoting element, are locked.
To operate the product
WARNING:
safety regulations for work in the vicinity of
overhead power lines.
WARNING:
underneath a branch that is being cut. This
could lead to serious or even fatal personal
injury.
WARNING:
electrically insulated. If the product touches
or comes close to high-voltage power lines
Make sure that the wall
Make sure that the
Observe the applicable
Never stand directly
This product is not
15