Tractel Tracpode PRO Manual De Instalación, De Utilización Y De Mantenimiento página 12

5.1. Installation of systems on brackets
Before using a system for the first time, it needs
to be installed on its bracket.
EN
5.1.1. Blocfor R EVO (Fig. 4a).
1� Position the Blocfor R EVO anchor point on
the bracket anchor plate.
2. Fit the two spacers, the clamping plate, the
two M12 screws and the two lock nuts in
succession (Fig. 2a).
3� Tighten the two lock nuts to a torque of 20
Nm ± 2 N.
 Installation complete.
5.1.2. caRol R PRO and caRol Duratech
(Figs. 4b & 4c).
1� Position the caRol winch on the bracket
plate.
2. Position the two holes on the caRol mounting
plate opposite the two corresponding holes
on the bracket plate.
3� Fit the two washers on the winch side, the
two M8 fixing screws, the two other washers
on the plate side and the two lock nuts in
succession (Fig. 2b & 2c).
4� Tighten the two lock nuts to a torque of 10
Nm ± 1 N�
 Installation complete.
5.1.3. caRol R TS150 (Fig. 4d).
1� Remove the
retaining screw and remove the cover.
2. Position the caRol winch on the bracket
plate.
3� Position the four holes on the caRol mounting
plate opposite the four corresponding holes
on the bracket plate.
4� Fit the four washers on the winch side, the
four M8 fixing screws, the four other washers
on the plate side and the four lock nuts in
succession (Fig. 2c).
5� Tighten the four lock nuts to a torque of
10 Nm ± 1 N.
6� Refit the cover and retaining screw.
 Installation complete.
12
adjustable lanyard
5.2. Installation of accessories on the
Tracpode Pro
5.2.1. Blocfor R EVO (Fig. 3a).
1� Place the bracket on the leg of the Tracpode
PRO bracket and press down on the foot
adjustment pin.
2. Lock the bracket to the leg with the pin and
bracket safety pin.
 Installation complete.
To install the cable in the pulley, see the manual
supplied with the Tracpode PRO devices.
5.2.2. caRol R PRO and caRol Duratech
(Figs. 3b & 3c).
1� Place the bracket on the leg of the Tracpode
PRO bracket and press down on the foot
adjustment pin.
2. Lock the bracket to the leg with the pin and
bracket safety pin.
3� Fit the crank handle, washer and nut in
succession (Fig. 2d).
4� Tighten the nut firmly with a spanner.
 Installation complete.
To install the cable in the Tracpode PRO, see
the manual supplied with the Tracpode PRO
devices.
5.2.3. caRol R TS150 (Fig. 3d).
1� Place the bracket on the leg of the Tracpode
cover
PRO bracket and press down on the foot
adjustment pin.
2. Lock the bracket to the leg with the pin and
bracket safety pin.
3� Pull the locking button and insert the crank
into the rectangular hole in the hub. (Fig. 2e).
4� Release the locking button and check that
the crank handle is securely locked in the
hub. (Fig. 2e).
 Installation complete.
NOTE: To make it easier to unwind the
cable without a load, the winch drum can be
disengaged as follows (Fig. 3e):