Descargar Imprimir esta página

Tractel Tracpode PRO Manual De Instalación, De Utilización Y De Mantenimiento página 17

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 65
• Inspect the entire length of the steel cable
and more specifically check for the following
damage:
• It is pinched.
• It has unravelled.
• It has corroded.
• Strands are cut.
• The sleeving is not in good condition.
• The wire thimble is missing or is deformed.
• The fall indicator has been triggered on the
cables equipped with it.
• One of the ends of the cable is non-
compliant.
• If the connector or hook at the end of the
cable is deformed or corroded, or if the
safety catch or locking system is no longer
functional or present.
NOTE: If one of the above types of damage
occurs, the cable must be taken out of service.
If in doubt or if you do not understand
this checklist, contact Tractel
12.2. Checking the Blocfor R EVO
The Blocfor R EVO must be checked in
compliance with the specifications of the manual
supplied with the device.
12.3. Checking the caRol R PRO, caRol
R TS and caRol Duratech winches
Position the caRol winch so that it can be
inspected from all sides.
The caRol winch must have the following
markings at least:
• The manufacturer's or supplier's name
• The equipment reference
• The batch or serial number
• The EN equipment standard followed by the
year of reference
• The logo; read the instruction manual.
NOTE: If any marking goes missing, the
affected equipment must be taken out of service.
The caRol bracket and winch accessory must
have the following at least:
• Its bracket for the Tracpode PRO
• A caRol cable wound on the drum
• The winch with all its components
• A removable crank handle with handle.
Inspect each side of the caRol winch and check
specifically for the following damage:
• The housings are deformed.
• The crank handle and handle are deformed.
• The incorrect winding or unwinding of the
whole cable.
• There is any corrosion.
• Any pins, screws or rivets are missing.
• The cable is damaged as per chapter 12.1.
damage occurs, the equipment must be taken
out of service.
In a safe environment with no risk of falling,
proceed as follows:
Install the Carol winch with its bracket on the leg
of the Tracpode PRO.
To check the correct operation of the lock, use a
.
®
weight weighing:
• 165 kg attached to the end of the cable for all
types of caRol winches.
Proceed to check the stopping of the weight as
follows:
1� Lift the weight by turning the caRol winch
2. Release the crank handle.
3� The locking of the weight must be done
4� Wait three minutes.
5� Bring the weight back down.
occurs after several jolts or if the weight goes
down before the three-minute delay, the product
must not be used and must be returned to Tractel
or an authorised repairer for an ASI.
The brackets for Tracpode PRO devices are
supplied separately. For the systems check, see
the corresponding chapters.
Position the bracket so that all sides of it can
be inspected, and if necessary, dismantle the
bracket system.
NOTE: If one of the above types of
crank handle clockwise as specified in the
winch marking.
immediately.
NOTE: If the locking is not immediate, if it
EN
17

Publicidad

loading