Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect the plug from the power source before making any assembly,
adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Changing Accessories with
Collet Wrench
Do not engage lock while
the Rotary Tool is run-
ning.
(Fig. 2, 3)
To loosen the Collet Nut 3, first press Shaft
Lock Button 2 and rotate the shaft by hand
until the lock engages the shaft preventing
further rotation (Fig. 2).
With the Shaft Lock 2 engaged use the collet
Wrench 10 to loosen the Collet Nut 3 if nec-
essary. The collet nut must be loosely thread-
ed on when inserting an accessory.
Change accessories by inserting the new one
into the collet as far as possible to minimize
runout and imbalance.
Certain applications benefit from having the
accessory mounted partially extended from
the collet. Ensure that the accessory does not
extend beyond 1/2 h in these cases (Fig. 3).
With the shaft lock engaged, finger tighten
the collet nut until the accessory shank is
gripped by the collet. Avoid excessive tight-
ening of the collet nut when there is no bit
inserted.
Changing Accessories with
EZ Twist Integrated Wrench /
Nose Cap
(Fig. 4)
The nose cap of your tool has an integrated
wrench allowing you to loosen and tighten
the collet nut without the use of the standard
collet wrench.
Unscrew the Nose Cap 5 from the tool, line-
up steel insert on inside of cap with Collet
Nut 3. With the shaft lock engaged, twist
nose cap clockwise to tighten, and counter-
clockwise to loosen.
10
1605A0014P 3100 202303.indd 10
page heading
Assembly
Fig. 2
Fig. 3
Fig. 4
TIGHTEN
2
10
TO
TO
TIGHTEN
LOOSEN
h
5
3
TO
TO
LOOSEN
3
MAX
1/2 h
4/5/23 7:04 AM
Publicidad
