Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing Screw Mandrel Accessories
Mandrel 401 is used with the felt polishing tip and wheels. Thread the tip on to the screw
carefully. The felt tip must thread down straight on the screw mandrel, and be turned all the
way to the collar.
Mandrel 402 has a small screw at its tip, and is used with emery cutting wheels and sanding
discs. Higher speeds, usually maximum, are best for most work, including cutting steel. Which
is shown here.
Before each use, check to make certain that all components are assem-
bled to accessory shank and that the drum is sufficiently expanded to
secure the band during use. If sanding band is loose on the drum during operation it may "fly"
off and strike you or bystanders.
To replace a band on the 407 Drum Sander, loosen the screw without removing it to contract
the drum then slide the old band off. Slide the new sanding band on and then expand the
drum by tightening the screw once again.
18
1605A0014P 3100 202303.indd 18
page heading
4/5/23 7:05 AM
Publicidad
