Publicidad
Idiomas disponibles
Idiomas disponibles
Balancing Accessories
For precision work, it is important that all ac-
cessories be in good balance (much the same
as the tires on your automobile). To true up
or balance an accessory, slightly loosen col-
let nut and give the accessory or collet a 1/4
turn. Re tighten collet nut and run the Rotary
Tool. You should be able to tell by the sound
and feel if your accessory is running in bal-
ance. Continue adjusting in this fashion until
best balance is achieved.
Fixing Stuck Collets
(Fig. 5)
It is possible for a collet to get stuck within
the collet nut especially if a collet nut is tight-
ened onto the tool without a bit in place.
If this happens, the collet can be removed
from the collet nut by pushing the shank of
an accessory into the hole in the collet nut.
This should cause the collet to pop out of the
collet nut.
reduce the risk of starting the tool accidentally.
ment dam age, property damage, or personal injury.
Whenever you hold the
tool, be careful not to cov-
er the air vents with your hand. This blocks
the air flow and causes the motor to over-
heat.
On/Off Switch
(Fig. 6)
The tool is switched "ON" by sliding the On/
Off Switch 1 from the marked "OFF" position
to any of the variable speed settings.
1605A0014P 3100 202303.indd 11
page heading
Assembly
Operation
Disconnect the plug from the power source before making any assembly,
adjustments or changing accessories. Such preventive safety measures
Always observe the following safety precautions in addition to the safe-
ty in structions on pages 2 through 7. Failure to do so may result in equip-
Fig. 5
Hanger
(Fig. 1)
The Hanger 9 is provided for the use of hang-
ing your tool while using the 225 flex shaft
attachment or for storage. The Hanger 9 can
be unsnapped from the tool in order to hang
the tool, however it should be snapped back
into place underneath the cord so it will be
out of the way while the tool is in use.
Fig. 6
1
11
4/5/23 7:04 AM
Publicidad
