Publicidad
at=rexe}
cel late)
Regarding the DIRECT button
Setting the DIRECT button to ON shortens
the signal path. The result is a higher
quality recording. The shorter path,
however, renders the BALANCE control
inoperative.
If playback starts instead of
recording
The cassette tab for that side has been
removed. To record on this cassette, cover
the hole with plastic tape. (See page 34.)
Set the TIMER switch to OFF
Otherwise, recording or playback will start
automatically when the power is turned on.
Is it necessary to set the MONITOR
button for recording?
No. The source mode is automatically
selected and SOURCE is displayed. If you
wish to monitor the recorded sound, press
the MONITOR button to select the TAPE
mode.
To start recording while the
cassette holder is open
If you press the @ button while the cassette
holder is open, the holder will close
automatically and the unit will switch to
recording pause mode. This function allows
you to start recording at a moment's notice.
Checking the recording time on a
tape
To check the remaining recording time on a
tape:
1 Press the RESET button to reset the
counter to 0.00.
2 Press >> to advance the tape to its
end. The number on the counter
shows the approximate recording
time.
To check the total recording time of a tape,
first rewind the tape to its beginning, then
follow the same steps as above. (See "The
Accuracy of the Linear Counter" on page
28.)
Publicidad
