Beurer BF 105 Instrucciones De Uso página 28

b) Delete individual saved value for a user
– Select a measured value in the measurements memory "Mem" and briefly press the [SET] button on the con-
trol unit to delete the stored value displayed.
– You can also do this immediately after the measurement is taken.
– Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do not want to
delete the value, confirm "NO" using the [SET] button.
c) Delete all stored values for a user
– Open the measurements memory "Mem" and press the [SET] button on the control unit for around 5 seconds
to delete all values.
– Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do not want to
delete, confirm "NO" using the [SET] button.
Changing the batteries
The control unit has a low battery indicator. The
teries are flat, and the
replaced. Connect the scale to the app again. The system time is updated.
NOTE:
• When changing the batteries, use batteries of the same type, make and capacity.
• Do not use rechargeable batteries.
• Use batteries free from heavy metals.
13. Cleaning and maintaining the device
The device should be cleaned from time to time.
This should be done using a damp cloth and, if necessary, a small amount of detergent.
IMPORTANT
• Never use abrasive solvents or cleaning products!
• Never submerge the device in water!
• Do not clean the device in a dishwasher.
14. Disposal
Empty, completely flat batteries must be disposed of through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to dispose of batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury
For environmental reasons, do not dispose of the device in the household waste at the end of its service life.
Dispose of the device at a suitable local collection or recycling point in your country.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equip-
ment). If you have any questions, please contact the local authorities responsible for waste disposal.
15. What if there are problems?
If the scale encounters an error during measurement, the following is displayed:
Display Cause
Maximum weight capacity of 180 kg
ERROR:_OVERLOAD
exceeded.
Batteries are nearly flat.
LOW_BATTERY
30 measurements have been stored.
MEMORY_FULL
ERROR:_CONTACT The electrical resistance between the
electrodes and the soles of the feet is too
high (e.g. with very hard skin).
symbol appears if the scale batteries are flat. In this case, the batteries should be
symbol appears in the display when the control unit bat-
Solution
Loads must be limited to 180 kg.
Replace the batteries (see section 12).
Transfer the measured values.
Repeat the measurement barefoot. Dampen
the soles of your feet slightly. If necessary,
remove hard skin on the soles.
28