Publicidad
Idiomas disponibles
Idiomas disponibles
per taal invullen InDesign!
Frame
Velcro
A
B
9. Adjust the length of the flexible exhaust hose by gently pulling the hose out.
10. Plug the product into the electrical outlet.
11. Adjust the front grille as desired and turn on the product.
Note
◊
The window seal can be used on tilt or horizontal
windows.
3.4 Removing the window seal
1.
Remove the outlet from the exhaust hose.
2. Pull one end of a sealed section of the window seal.
3. Close the window.
6. Adjust the length of the flexible exhaust hose and avoid bends in
the hose. Then place the product near an electrical outlet.
Windowframe
C
7.
Remove the back of the tape and apply the Velcro
to the non-hinged sides of your window and frame
as shown below. Make sure the window can close
properly with the Velcro.
8. Attach the window seal (A) to the Velcro; make
sure there is no gap where air can escape between
the frame and the window seal. The zipper opening
on the window seal (B) should be located where the
outlet hose (C) can easily reach it. Open the zipper
opening so that the outlet hose can be inserted and
then close it tightly to hold the outlet in place.
C
Tilt window
B
B
Horizontal window
English
C
39
Publicidad
