Turning On And Off; Cooling; Ventilate; Dehumidifying/Drying - auronic AU3263 Manual De Instrucciones

3.6 Turning on and off

1. Press POWER to turn on the product. By default, the product operates in FAN mode.
2. Press MODE to select the desired operating mode.
3. Press POWER again to turn the product off.

3.7 Cooling

Select cooling mode to lower the temperature in the room.
1. Press MODE repeatedly until the COOL mode indicator lights up.
2. Press UP/DOWN to adjust the temperature displayed on the display. The temperature can be
adjusted between 16°C and 32°C.
3. Press SPEED repeatedly until the desired fan indicator lights up.
4. Press SWING to adjust the direction of air flow horizontally.
Note
◊ The product stops when the room temperature is lower than the selected temperature.

3.8 Ventilate

Press MODE repeatedly until the FAN SPEED indicator lights up.
Press SPEED repeatedly to select the desired fan speed.
Note
◊ In ventilation mode, the air in the room is circulated but not cooled.

3.9 Dehumidifying/Drying

Press MODE repeatedly until the Dehumidify mode indicator lights up.
Note
◊ In this mode, the fan speed switches to low speed and cannot be selected.
◊ You must connect the drain hose to the drain opening on the bottom of the product.

3.10 Heating

1. Press MODE repeatedly until the HEATING indicator lights up.
2. Press UP/DOWN to set the desired temperature. The fan speed can also be set.
Note
◊ The drain hose must be attached for continuous operation.

3.11 Sleep mode

Press SLEEP until the SLEEP indicator lights up.
English
41