PUFF PFEN044 Manual De Instalación Y Mantenimiento página 22

3 • SPECIAL REQUIREMENTS FOR THE INSTALLATION SITE
3.1 • The environment where the oven will
be installed must be well ventilated and
fitted with all the openings prescribed
for environments with gas installations,
in compliance with national and local
legislation.
3.2 • Current IEC (International Electrotechnical
C o m m i t t e e ) r e g u l a t i o n s r e q u i r e t h e
installation of a multiple pole switch
between the oven and the electrical power
supply; the switch must have a contact
gap of at least 3 mm on each pole.
3.3 • The oven necessarily needs a cold water
supply, which must be equipped with a
softener with suitable flow rate and
pressure (see the technical data and
chapter regarding the water connection).
For the supply line, a shut-off valve must
be installed upstream of the appliance.
4 • STATUTORY REQUIREMENTS, TECHNICAL REGULATIONS AND DIRECTIVES
Throughout installation it is vital to observe
the following requirements:
4.1
Throughout installation it is vital to observe
the following requirements:
4.1 • a n y h e a l t h a n d h y g i e n e s t a n d a r d s
applicable to kitchens and eating places;
4.2 • local and/or territorial building regulations
and fire prevention standards;
4.3 • current accident prevention guidelines;
3.4 • A w a t e r d r a i n a g e s y s t e m m u s t b e
available in the room, positioned in the
immediate vicinity of the appliance with the
characteristics described in the chapter
"Water connection and drainage" of this
manual.
3.5 • The electrical isolating switch and the
water shutoff valves must all be located
near to the appliance, within easy reach for
the user.
4.4 • IEC requirements relating to electrical
systems;
4.5 • the regulations of the electrical power
supply company or agency;
4.6 • any other local regulations.
90041240rev00
EN - 22 -