PUFF PFEN044 Manual De Instalación Y Mantenimiento página 24

6 • ELECTRICAL CONNECTIONS AND EQUIPOTENTIAL BONDING
6.1 • As this oven is a type Y appliance (oven
without power cable and plug), the cable
and other hardware needed to make
the connection to the electrical power
supply must be provided by the installer.
The cable must satisfy the requirements
indicated in table 1 "General data". As
already mentioned, the oven must be
connected to the power supply by way
of a multiple pole main isolating switch
ensuring a gap between open contacts of
at least 3 mm on each pole.
6.2 • To access the power terminal block,
the oven panel must be removed by
unscrewing the fastening screws.
6.3 • The cable must be fed in through the
clamp from the back. The individual wires
are then fastened to the corresponding
terminals of the terminal board. The earth
wire must be longer than the other wires,
so that in the event of the cable being
jerked or the clamp broken, the live wires
will disconnect first.
Check the efficiency of the isolating switch.
6.4 • Connect the power cable according to the
following diagrams:
POWER SUPPLY CONNECTION DIAGRAM
3 AC 400 V + N + PE
Terminal block:
L1
L2 L3
Filters:
L1
AC 230 V + N + PE (only for 023-041-051)
3AC 400 V + N + PE
PE
N
3AC 230 V + PE
PE
L2 L3
L1
Terminal block:
POWER SUPPLY CONNECTION DIAGRAM
L1
Filters:
L1
The manufacturer is not responsible for connections other than those indicated in this diagram.
Il costruttore non è responsabile per collegamenti diversi da quelli indicati nel presente schema.
L1
Terminal block:
The manufacturer is not responsible for connections other than those indicated in this diagram.
Il costruttore non è responsabile per collegamenti diversi da quelli indicati nel presente schema.
Filters:
FL1 FL2 FL3
FL
FL FL
FL1 FL2 FL3
FL FL
FL
The manufacturer shall not be liable for
connections different to those indicated
in the present diagram.
90041240rev00
FL1 FL2 FL3
EN - 24 -
L2 L3
N
3 AC 230 V + PE
3AC 230 V + PE
3AC 400 V + N + PE
L3
L2
AC 230 V + N + PE (only for 023-041-051)
L2 L3
N
3AC 230 V + PE
N
L
L3
L2
AC 230 V + N + PE
only for Mod. PFEN044
AC 230 V + N + PE (only for 023-041-051)
L N
FL1 FL2
FL FL
PE
FL1 FL2
FL
PE
FL
FL1 FL2
FL FL
PE
FL1 FL2
FL
PE
FL
FL1 FL2
FL
PE
FL
FL1 FL2
FL
PE
FL