Tornado TORRENT 43 Manual De Operaciones Y Mantenimiento página 29

Changing the Sweeper Side Brush
The side brushes are subjected to wear. On abrasive surfaces, wear to the brushes
is faster than on smooth floors.
It is necessary to change the sweeping brushes if these are worn or damaged.
Changing due to wear is necessary if the sweeping result of the side brushes is
visibly worsened and it is no longer possible to
readjust.
• Put ignition key into the "0" position and remove key
• Raise the side brushes (transport position)
• Remove the side brushes (undo wing bolt).
• Change the side brushes.
• Put the side brushes on the take-up of the driver and fasten.
Setting the Side Brush
It is necessary to adjust the side brush if the wear of the brushes visibly makes the
sweeping result of the side brushes
worse.
• Set down the sweeper onto a level, dry and protected surface.
• Raise the side brushes (transport position)
• Open front panel
• Undo the knurled nuts at the front left and/or right of the side brush
adjustment.
• Turn adjustment forwards to lower the side brushes further
• Fasten both knurled nuts again.
• Close front panel.
Fig.3
CLEANING
27