Tornado TORRENT 43 Manual De Operaciones Y Mantenimiento página 30

CLEANING
Changing the Front Sealing Rubber
The front sealing rubber must be replaced if there are tears or if it is worn, to guarantee a
good sweeping result.
• Put ignition key into the " 0 " position and remove key.
• Raise the side brushes (transport position)
• Undo all four nuts of the sealing rubber and remove
• Replace front sealing rubber.
• Refit the front seal.
Setting/Replacing Side Sealing Rubber
The basic setting of the side sealing rubber is 1mm.
• Put ignition key into the " 0 " position and remove key.
• Tip the machine as required.
• To set the height, undo the fastenings (four nuts), readjust or replace the side
sealing rubber, align and fasten.
28