Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
NOTE: This pump is designed for minimum maintenance. The motor bearings
are self-lubricating. Inspect the pump and components regularly for fuel leaks
and make sure the hose and power cord are in good condition. If damaged,
replace before use. Keep the pump exterior clean to help identify leaks.
IMPORTANT: Do not use this pump for water, chemicals or herbicides.
Dispensing any fluid other than those listed in the owner's manual may damage
the pump (see BEFORE YOU BEGIN: Fueling Compatibility Statement at front
of the owner's manual). Use of the pump with unauthorized fluids will void the
warranty.
Clean or Replace Check valve / Strainer
1.
Turn the pump off and disconnect from power. Using 6mm hex wrench,
remove the strainer access cover, O-ring, and check valve/strainer
assembly and inspect for damage or clogs (see Figure 1). Clean the
strainer with a soft-bristled brush and solvent. If the strainer is very dirty,
compressed air may be used. If damaged, replace the check valve/strainer
assembly.
2.
Clean the strainer access cover and O-ring. Coat the O-ring lightly with
grease. Reinstall the check valve/strainer, O-ring and strainer access cover.
Ensure the O-ring is properly seated and tighten securely.
O-ring
Strainer
Access
Cover
Figure 1
8
EN
Check valve/
Strainer
1
2
Publicidad
