Electrical Connections - Erreka ZEUS T1500 Manual Del Instalador

6

ELECTRICAL CONNECTIONS


The electrical cable section is indicated in "Fig. 1 Single leaf up-and-over door" on page 35.
Fig. 3 Control board connections and components
INSTALLING AND PROGRAMMING

Disconnect the electrical
before manipulating
board or the elements connected to
the cable connectors.
Connections
STOP Emergency pushbutton
A.T. Key command
S.G.
Safety device (photocell or mechanical
strip)
FCA Opening
limit switch
installed and connected)
FCA Closing limit switch (supplied installed
and connected)
AUX Output (24Vac)
ANT Antenna
R.E.
Connector for plug-in receiver (except
RSD)
ATP Anti-crush sensor connector LTT15
SENS
M
Motor (supplied
connected)
C
Capacitor (supplied
connected)
DEST Flashing light (230Vac)
LC
Courtesy light (230Vac)
DIPs and potentiometers
SW1 Programming DIPs
PM
Torque adjustment
T.E
Standby adjustment
T.M. Operation time adjustment
Fuses
F1
Main fuse (5A)
F2
Electronic fuse (2A)
LEDs
DL1
Operation device activated
DL2
STOP button closed
DL3
Photocell contacts closed
DL4
FCA closed
DL5
FCC closed
DL6
Motor operation
ZEUS operator for up-and-over doors
power
the control
(supplied
installed and
installed and
45