Starting Up; Final Checks; User Instruction - Erreka ZEUS T1500 Manual Del Instalador

9

STARTING UP

Final checks

Following installation and programming, start up the
operator and check the devices installed:
1 Check the correct operation of the key commands
(pushbutton, wall key, etc).

See "Operation modes" on page 38.
2 Check the correct operation of the safety devices
(photocells).

See "A- Detection by photocell or mechanical
strip (S.G)" on page 38.
3 Place an obstacle and make the door collide with it
in order to check operation in the event of collision.

See "B- Direct detection (built-in safety)" on
page 38.
4 If everything is correct, position the operator cover.

If the system does not work correctly, find out
why and put it right (see section "Failure
diagnosis" on page 48).
INSTALLING AND PROGRAMMING

User instruction

1 Instruct the user with regards to the use and
maintenance of the installation and provide him/her
with the user guide.
2 Signpost the door, showing that it opens
automatically and indicating how to operate it
manually. Where appropriate,
operation is using the remote control (emitter).
ZEUS operator for up-and-over doors
indicate that
47