Instructions For Use; Before Initial Operation; Inserting/Replacing The Battery - Flex KNE 16 18-EC Instrucciones De Funcionamiento Originales

Instructions for use

WARNING!
Remove the battery before carrying out any
work on the power tool.

Before initial operation

Unpack the power tool and check that there
are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger oper
ating manual.

Inserting/replacing the battery

Press the charged battery into the power

tool until it clicks into place.
To remove, press the release button (1.)

and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
16
Battery state of charge
Press the button to check the state of

charge on the state of charge indicator
LEDs.
-
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Switching on and off
Short-term operation without detent
Press switch (1.), push towards front and

hold (2.).
To switch off, release the switch.

Non-stop operation with detent
Press switch (1.), push towards front (2.)

and engage at front end by applying pres-
sure (3.).
KNE 16 18-EC