Publicidad
Idiomas disponibles
Idiomas disponibles
KNE 16 18-EC
Punch:
Keep the power tool horizontal.
Remove the battery.
Loosen the thumb wheel by min. three
revolutions.
Push the punch out of the groove of the
punch holder (1.).
Pull out the punch (2.).
Grease the new punch and die holder with
"G1" lubricating grease.
Hook the punch into the groove of the
punch holder (3.)/(4.).
Insert the punch into the housing.
Insert the die holder (5.).
Tighten the thumb wheel (6.).
Spare parts and accessories
Other accessories can be found in
the manufacturer's catalogues. Exploded
drawings and spare-part lists can be found
on our homepage: www.flex-tools.com
Disposal information
WARNING!
End-of-life power tools must be rendered
inoperable before disposal.
For mains-operated power tools, remove
–
the mains cable.
For battery-operated power tools, remove
–
the battery.
EU countries only
Do not dispose of electric power tools
in the household waste!
In accordance with the European directive
2012/19/EU on Waste Electrical and Elec-
tronic Equipment and its incorporation into
national law, end-of-life electric power tools
must be collected separately and recycled
in an environmentally-friendly manner.
Recycling raw materials instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally-friendly
manner. Plastic parts are identified for recy-
cling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open end-of-life
batteries.
EU countries only: defective or end-of-life
batteries must be recycled in accordance
with directive 2006/66/EC.
NOTE
Please ask your dealer about disposal
options.
19
Publicidad
