Publicidad
Sección 3 — Verificación del hardware
Section 3 — Hardware Checkout
Section 3 — Hardware Checkout
C
C
H
H
1
1
C
C
H
H
2
2
C
C
H
H
3
3
3.2.3 Configuración de la dirección del nodo Modbus
3.2.3 Setting The Modbus Node Address
3.2.3 Setting The Modbus Node Address
Los actuadores deben tener direcciones de nodo Modbus únicas. La dirección de nodo se ajusta mediante
The actuators are required to have unique Modbus node addresses. The node address is set using a rotary
The actuators are required to have unique Modbus node addresses. The node address is set using a rotary
un interruptor giratorio ubicado en la placa frontal del actuador. Gire a la dirección deseada utilizando un
style switch located on the actuator front plate. Turn to the desired address using a small, flat bladed
style switch located on the actuator front plate. Turn to the desired address using a small, flat bladed
destornillador pequeño de punta plana.
screwdriver.
screwdriver.
Once the node address has been set, the actuator may be powered up.
Una vez configurada la dirección del nodo, puede encenderse el actuador.
Once the node address has been set, the actuator may be powered up.
Power must be cycled to the actuator before a new node address setting will be accepted by the actuator.
Power must be cycled to the actuator before a new node address setting will be accepted by the actuator.
Debe desconectarse y volverse a conectar la alimentación del actuador antes de que este acepte un nuevo ajuste
de dirección de nodo.
3-8
3-8
3-8
Figure 3-6. Actuator daisy chain w/ plug connections
Figura 3-6. Actuador en cadena con conexiones de enchufe
Figure 3-6. Actuator daisy chain w/ plug connections
Figura 3-7. Actuador Modbus con cubierta retirada
Figure 3-7. Modbus actuator - cover removed
Figure 3-7. Modbus actuator - cover removed
FEMALE END VIEW
FEMALE END VIEW
TYPICAL OF ALL
TYPICAL OF ALL
SERVO CONNECTORS
SERVO CONNECTORS
VIEW OF ACTUATOR W/COVER OFF
VIEW OF ACTUATOR W/COVER OFF
BLK TO PIN #2 24VDC RETURN
BLK TO PIN #2 24VDC RETURN
BRN TO PIN #1 RS-485 (-)
BRN TO PIN #1 RS-485 (-)
RED TO PIN #5 24VDC SUPPLY
RED TO PIN #5 24VDC SUPPLY
ORG TO PIN #4 RS-485 (+)
ORG TO PIN #4 RS-485 (+)
GRN TO PIN #3 EARTH GROUND
GRN TO PIN #3 EARTH GROUND
Nro. de pieza 750-366
Part No. 750-366
Part No. 750-366
Hawk 1000
Hawk 1000
Hawk 1000
Publicidad
